Floor standing/Bench top
Closed loop down force control
Ultra high data acquisition
Mix and match module per need
Nano to macro range
Easy to add new modules in future
Integrated imaging options like Interferometer, Confocal Microscope, AFM, Raman and more.
Perform multiple ASTM, ISO, DIN tests
Nano nN to 3000mN, Micro 3000mN to 30N, Macro upto 10000N (more ranges available).
Thread Forming, Cutting and Drilling tests
For testing and developing lubricants, metal working fluids, taps, cutting liquid, process development
The Recipe style software, close loop controllers and automatic position correction hardware allows to tap, drill or cut many locations with high accuracy.
Real time videos and images are taken during the test that allows to precisely study test interface.
Easy to use viewer software to compare multiple files, cycles. Several statistical parameters such as mean, standard deviation, frequency distribution, data filtering, averaging across one or multiple files is very easy to do.
Graph shows three different lubricant across 5 automatic tests (Both Forward and Reverse )
Module is mounted on XY Stage. Tests including Pin on Disk,Ball on Disk can be performed.
Module is mounted on XY Stage. Tests including Pin on plate,Ball on plate, Linear Wear Test can be performed.
Module is mounted on XY Stage. Rings, shafts, seals and more can be tested.
Upper sample is rotated which can be used with Z motion.
4Ball, Tapping, Drilling,Twist Compression
The High Frequency Reciprocating Rig- HFRR (ASTM D6079) to evaluate diesel fuel lubricity. The ball is caused to rub against the disk 1mm stroke at a frequency of 50 Hz for 75 min. Real time down force control , piezo sensors to measure inline friction makes this module very reliable and repeatable.
The standard Test to determine extreme pressure, friction wear properties of lubricant greases, solid bonded films, gear and hydraulic fluids, lubricating oils. All tests are done in oscillation mode under controlled environmental conditions. ASTM D5706, D5707, D6425, D7217, D7420, D7594 ,D7421 , DIN 51834 /2/3/4/5/6/7/8/9
The block on ring module is typically used to evaluate friction wear of materials, lubricant where a ring/bearing/shaft is rotated under axial load. ASTM G77, D2509, D2714, D2782, D2981, D3704
4 ball module is used to measure friction, wear and EP properties of oils and greases. The test involves rotating one ball on three stationary balls at controlled environmental conditions. Confirm to meet ASTM D2266, D4172, D5183, D2596, D2783, VW PV1444, PV1454, DIN51350-1, DIN51350-2, DIN51350-4, DIN51350-6, IP 300, IP 299, CEC L-45-A-00 (KRL) and more.
This test helps evaluate friction and wear parameters of piston ring liner material in presence of engine oils. Few applicable standards are ASTMG181-11 and more. The test setup allows to mount real pieces of actual piston ring and liners.
This test (ASTM 3702) helps evaluate friction and wear parameters of self-lubricated materials in thrust washers ASTM3702
The module allows to measure wear, friction while sliding using pin/ball on disk setup. ASTM G 99,
Stribeck curve is a plot between coefficient of friction and bearing number. In all modules listed above user can change the load and velocity to automatically plot Stribeck Curves with ease.
The tribometer comes with integrated imaging modules such as interferometer, AFM, Raman confocal microscope, for sub nm resolution, 3D surface imaging on the platform without taking sample out of tool.
Standard configuration has X,Y,Z plus an add on interchangeable motion axis drive. This unique multi axis drive combination allows to create any custom motion to simulate testing conditions close to real life scenario
Easy to swap modules. The clamps allow to swap the modules without the need of any additional tools.