The MFT5000 is a versatile multi-functional mechanical property tester capable of simulating a vast number of tribology and wear tests on the same platform. This application note shows how the MFT5000 can be used to study materials, coatings and lubricants using linear reciprocating test setup. This test method covers a laboratory procedure for determining the wear and friction of materials, liquid and lubricants etc. during sliding using a pin on plate or ball on plate setup.
This test method covers a laboratory procedure for determining the wear and friction of materials, liquid, lubricants etc. during reciprocating sliding using a pin/ball-on-plate setup. The tester pushes a stationary pin/ball to press against the reciprocating plate at a pre determined force and moves it in a linear reciprocating manner at the set frequency. During the test coefficient of friction (COF), friction force, wear and several other parameters are measured and reported. The setup for dry conditions is shown in Figure. This set up is ideal for characterizing tribological properties of alloys, ceramics, polymers, bulk materials, coatings, solid lubricants etc. with respect to a counter material in non-lubricated conditions. Figure shows the top view of the set up for lubricant container in which samples can be tested in lubricated conditions.
Figure shows the friction curve from a typical reciprocating test. The change in friction values from negative to positive corresponds to the change in direction during the test. The data can be collected up to 5000 points per second. Several other channels such as temperature, coefficient of friction, wear etc. can also be recorded during the test. The high-end electronics and the high data acquisition rates makes it possible to get useful insights in the test including the static to dynamic peaks as the test changes direction.
Rtec multi-function tribometer comes with an optional inline 3D Profilometer. The profilometer automatically measures the surface topography of the wear track at pre-set intervals defined by the user e.g. after a certain number of cycles, duration of time or at the on-set of an event such as increase in friction. The XY stage is equipped with advanced encoders to automatically move the sample between the test and image area. The ability to quantifiably characterize the change in surface topography and wear track with time and combining it with friction data makes the analyses extremely powerful.